Ankrui Sensor Digital Display Instrument Frequency Speed Analog Display Table

NegotiableUpdate on 01/08

Model

Nature of the Manufacturer: Producers

Product Category

Place of Origin

Online Consult

Overview

Sensor Digital Display Instrument Product Description Brand Ankerui Electric Model PZ72L-DI Item Number PZ72L-DI Installation Method Embedded Type Electronic Measurement Object Input 4-20mA Measurement Range Adjustable Range Processing Customization No Import No Origin Jiangsu 1 Overview PZ series single-phase meter, using AC sampling technology, can directly or indirectly measure the electrical energy, power, voltage, current, frequency, etc. of a phase in a single-phase or three-phase power grid

Product Details

Sensor digital display instrument product description

brand	Ankerui Electric	model	PZ72L-DI
Item Number	PZ72L-DI	Installation method	embedded
type	electronic type	Measurement object	Input 4-20mA
measurement range	Adjustable range	Processing & Customization	No
Is it imported	No	Place of Origin	Jiangsu

1 Overview

The PZ series single-phase meter uses AC sampling technology to directly or indirectly measure the electrical energy, power, voltage, current, and frequency of a phase in a single-phase or three-phase power grid. It can be used for local display and can also be connected to industrial control equipment to form a measurement and control system.

The instrument may have an RS-485 communication interface and use Modbus RTU protocol; Can be equipped with analog output, relay alarm output, and switch input/output. According to different requirements, parameters such as transformation ratio, alarm, and communication can be set and controlled through the dashboard buttons.

2 Product Model and Specifications

3 Technical parameters

4 Installation Guide

When installing the instrument, loosen the locking screws of the fixed bracket, remove the fixed bracket, insert the instrument into the installation hole, install the fixed bracket, tighten the screws to ensure that the instrument is installed firmly and not loose. The appearance of 48 is a clamp spring compression installation. (The diagram shows the installation schematic of different wiring methods)

Voltage input: The input voltage should not exceed 120% of the rated input voltage of the product, otherwise PT should be considered. A 1A fuse must be installed at the voltage input end.

Current input: AC current input should use an external CT; if other instruments are connected to the CT used, the wiring should be in series; Suggest using a wiring harness instead of directly connecting to the CT for easy disassembly and assembly;

Before removing the current input connection of the product, be sure to disconnect the CT primary circuit or short-circuit the secondary circuit first;